Effects of processing technologies on functional properties of sweetpotato-derived ingredients.
| Processing method | Raw material | Representative processing parameters (examples) | Key physicochemical changes | Measurable outcomes (examples) | Functional property modification | Food industry implication |
|---|---|---|---|---|---|---|
| Sun/Cabinet/Tunnel drying [64] | Roots and leaves | Hot-air or cabinet drying typically occurs at 50–60°C for 4–8 h; open-air sun drying is highly variable; some OFSP cultivars were dried at 58°C for 4 h. | Moisture reduction; partial degradation of vitamin C and carotenoids; concentration of minerals, fiber, and carbohydrate due to water loss. | Sun-drying of OFSP slices caused trans-β-carotene losses up to ~83% in some cultivars, whereas cabinet drying gave lower losses (~28–47%); tunnel/solar dryers retained ~87–90% provitamin A (~10–13% loss). | Improved shelf life and bulk density, but with reduced retention of heat-sensitive nutrients under higher temperature or uncontrolled sun exposure; nutritional changes depend strongly on time-temperature profile and dryer type. | Flour and powder production where moderate losses of carotenoids and vitamin C are acceptable; more controlled cabinet/tunnel drying is preferred for high β-carotene retention. |
| Freeze-drying [65, 66] | Roots and leaves | Typical protocol: blanch (optional), freeze to about –28 to –33°C, then vacuum freeze-dry at ~35–80 Pa for 12–20 h. | Minimal thermal degradation; sublimation preserves cell structure; limited oxidation; good retention of color and rehydration capacity. | Under optimized conditions, dehydration below 60°C (including freeze-drying) can retain approximately 70–90% of β-carotene and 75–90% of overall vitamins in sweetpotato products. | High retention of bioactive compounds and natural color; excellent rehydration; near-fresh sensory quality compared with hot-air and sun drying. | Premium functional powders for nutraceuticals, high-value ingredients, and applications where maximal retention of carotenoids, phenolics, and vitamin C is required. |
| Spray drying [67] | Extracts (juices, purees, polyphenol or carotenoid extracts) | Inlet temperatures often ~140–180°C; outlet temperatures ~70–90°C; carrier solids (e.g., maltodextrin) ~5–20%. | Rapid dehydration into microencapsulated powders; reduced water activity; potential partial loss of heat-sensitive compounds, but improved handling and stability. | Spray-dried sweetpotato starch or extract shows reduced bulk density, a narrower particle-size distribution, and improved flow; encapsulation of carotenoids/phenolics can maintain a higher proportion of antioxidant activity during storage compared with non-encapsulated liquids (values are formulation-dependent). | Enhanced stability, flowability, and dispersibility of bioactive compounds; enables controlled release and improved shelf life compared with liquid forms. | Encapsulated carotenoid and polyphenol ingredients, instant beverages, powdered flavors and colorants, and nutraceutical powders. |
| Extrusion cooking [68] | Root flour/starch, composite flours | Barrel temperature often ~100–155°C (multi-zone profiles), moisture ~15–25%, screw speed ~80–140 rpm, die diameter ~4–10 mm. | Starch gelatinization and loss of crystallinity; protein denaturation; partial dextrinization; formation of porous expanded structures; potential formation of some resistant starch fractions. | At 150–155°C during extrusion, products can achieve high expansion, with a specific volume of around 2.44 mL/g and reduced hardness (~985 g), compared with unextruded flour (2.17 mL/g; hardness ~1,637 g). Resistant starch formation depends on formulation and cooling, with some systems reporting increased slowly digestible/resistant fractions. | Improved expansion, texture, and digestibility; modified glycemic response; formation of ready-to-eat snack structures while retaining acceptable micronutrient levels when parameters are optimized. | Snacks, breakfast cereals, instant porridges, and ready-to-eat products based on sweetpotato flour or composite blends. |
| Fermentation (lactic, mixed) [63] | Roots and leaves; juices or purees | Lactic acid bacteria fermentation typically 24–72 h at ~30–37°C; inoculum ≥ 106 CFU/mL; possible co-fermentation with yeast or other microbes. | Microbial hydrolysis of macromolecules; changes in phenolic profiles; reduction of some antinutritional factors; acidification and flavor development. | In lactic-fermented purple sweetpotato juice, ABTS [2,2′-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid)] radical scavenging activity increased by ~20%; DPPH and ·OH scavenging increased by ~11–20%; total phenolic and flavonoid contents increased relative to unfermented juice. Fermented sweetpotato matrices show sustained high phenolic content and antioxidant activity over 24–72 h. | Improved bioavailability of phenolics, enhanced antioxidant capacity, and reduced selected antinutritional factors; development of acidic, mildly effervescent sensory profiles. | Functional beverages, fermented purees, probiotic or symbiotic products based on sweetpotato roots or juices, and, potentially, leaf-containing formulations. |
| Blanching [69] | Leaves (and sometimes roots prior to drying) | Hot-water blanching is typically ~85–95°C for 1–5 min; steam blanching is also used before drying or freezing. | Enzyme (e.g., polyphenol oxidase, peroxidase) inactivation; partial leaching of soluble solids; pigment stabilization; partial loss of vitamin C, depending on severity. | Proper blanching before drying preserves more color and vitamin A activity than unblanched sun-drying; cabinet/hot-air drying after blanching retains more ascorbic acid than sun-drying in several sweetpotato studies (exact losses depend on the time-temperature regime). | Improved color retention, reduced enzymatic browning and bitterness, better flavor and texture in rehydrated leaves and root slices. | Pre-treatment for vegetable-type leaf products and powders, frozen or dried root slices, and intermediate ingredients for further processing. |
| Roasting/baking [70, 71] | Roots (whole, sliced, or pureed) | Baking commonly ~180–220°C for 20–60 min; roasting conditions vary with product thickness and desired browning. | Maillard reactions and caramelization; moisture loss; partial starch gelatinization and dextrinization; increased sweetness via maltose formation. | Baking at ~200°C reduces starch and markedly increases maltose, which becomes the major sugar of baked roots; antioxidant levels can be maintained or slightly increased in some conditions, but vitamin C and some carotenoids may decline; crust color and aroma intensify. | Flavor enhancement, aroma development, desirable browning, and softer texture contribute to consumer-acceptable baked and roasted products. | Bakery and snack products such as baked sweetpotato chips, wedges, breads, and purees. |
| Enzymatic hydrolysis [72, 73] | Roots (starch-based substrates, purees) | Liquefaction and saccharification using α-amylase, glucoamylase, or other carbohydrases; typical conditions ~50–65°C, 1–4 h, pH optimized for the enzyme used. | Starch breaks down into dextrins and oligosaccharides; reduced viscosity; increased soluble solids and sweetness; potential formation of resistant oligosaccharides depending on enzyme and time. | Conversion of sweetpotato starch to syrups with high dextrose equivalent; viscosity can drop several-fold; increasing soluble solids and sweetness enables direct use as sweeteners or fermentation substrates. | Increased sweetness, reduced viscosity, improved processability in beverages and syrups; generation of substrates for fermentation or prebiotic applications. | Syrups, beverages, confectionery, and substrates for bioethanol, organic acids, or probiotic fermentations. |
| Solvent/green extraction [74] | Leaves and roots (polyphenols, carotenoids, anthocyanins) | Conventional solvent extraction with aqueous ethanol/methanol (often 50–80% v/v) at ~25–60°C; advanced green methods may use ultrasound, microwave, or pressurized liquids. | Isolation and concentration of phytochemicals; possible structural modification of sensitive compounds depending on solvent, temperature, and time. | Optimization studies on purple sweetpotato report anthocyanin yields of 1.0–1.5 mg/g DW in dehydrated material under optimal conditions, with improved color stability due to acylated structures; leaf extractions can yield total polyphenols of several g GAE/100 g DW depending on the solvent and cultivar. | Concentration of antioxidants and pigments; improved control over dosage and formulation; potential to tailor antioxidant and color intensity in final products. | Nutraceuticals, functional beverages, natural colorants, antioxidant food additives, and ingredient systems for clean-label formulations. |